How to paint brake calipers without removing them

Would you like to treat your car to a visual highlight? Then you are exactly right here! Today we dare to pimp your braking system together. Because what looks sportier and cooler than a conspicuously colored brake caliper?

And you don’t even have to go to the workshop for that. We’ll show you how you can paint the brake caliper yourself step by step with brake caliper paint. Not only does it look good, it also saves you a ton of money! We’ll show you how easy the process is.


Step 1: Remove the wheel

Of course, in order to be able to work on the brake system, you first have to remove your bike. All the work would be easiest on a lifting platform, but a jack will do the job too!

Step 2: Remove the rust (if any)

With the supplied wire brush, you can first tackle the rust on your brake system. It is important that the loose rust particles disappear completely. Then the paint will hold up better later!

Step 3: Clean the brake

Use a wire brush and brake cleaner to remove the last bit of dirt.

Tip: give the brake cleaner a little time to evaporate. So don’t start painting right away!

Step 4: Tape the brake

You should tape your brake properly. In particular, the rails of the guide bolts, the vent screw, the support of the brake pads and the holes for the spring clip should definitely remain free of paint. You can also protect your brake disc with a sheet of paper.

Step 5: Mix the paint

The varnish and hardener are already dosed so that you just have to mix them together. It is important that you stir well! You will even be sent a spatula for this. Practically! Then you let the paint rest for 15 minutes. And then it can start!


Tip: First prepare all the brake calipers and only then do you start mixing the paint. Once it has been touched, you have a good 2 hours to apply it. So it’s better if you don’t have to brush and clean too during this time!

Step 6: Apply varnish

With the supplied brush you now apply the paint thinly. Make sure that no unsightly runners form! Don’t worry if the first layer doesn’t completely cover you, you can apply more layers until you are satisfied with the result.

Tip: Let each layer dry for at least 15 minutes before you apply another layer. Normally two to three thin layers should be sufficient for a good result!

And? Has turned out to be a really great result, right? Not only does it look good, it is also heat and chemical resistant and even protects your brake caliper from corrosion!

Author: Nabeel K
Email: nabeel@wheelsjoint.com



Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments